Slope Mower ZMT-E 160
All FERRI Offset / In Line Slope Mowers allow you to mow behind the tractor or just turn a lever and move the mower to the side of the tractor. This allows you to mower to the side of the tractor on slopes without having to drive your tractor on the slope. The ZMT Series will rotate the head up to 90° straight up or down to 45° on a slope. The ZME-E is specially designed to allow the mower to move the maximum length to the side. This helps ensure that the tractor does not have to drive on a slope. FERRI has accomplished this by moving the gear box to the outside of the mower head. It is strongly recommended that the ZMT-E be used in applications where you are mowing a downward slope. If mowing on a upward slope special attention must be take for the gear box not to contact the ground.
Tractor Minimum Requirements
Your tractor must have the following requirements to use this model:
Engine Horsepower:50 HP
Minimum Tractor Weight:4900 Lbs.
Minimum Tractor Width:5′ 11″
If your tractor does not meet these minimum requirements, you need to select a smaller model to meet your tractor specifications.
ZMT-E 160 Specifications
- Tractor Horsepower: 50 to 60 HP
- Tractor Weight (Minimum): 4900 lbs.
- Tractor Width (Minimum): 5′ 11″
- Cutting Width: 5′ 4″
- Max. Sidesliding: 9′ 2″ (From tractor center line to head edge)
- Flail Head Angle: + 90° to - 45°
- PTO RPMs: 540
- Belts: 3
- “Y” Blades: 40
- Hammer Blades: 20
- Blade Tip Speed: 1800 (in/sec)
Features and Benefits
To view Features Details, click on the corresponding Accordion Tab in the right sidebar area.
See Product Brochures for more details.
- Floating Frame
- Self Lubricating Joint
- Hydraulic Breakaway
- Hydraulic Hose Supports
- Protected Cylinder
- Adjustable Rear Guard
- Adjustable Rear Roller
- Multi-Use Flails
- Hammer Flails
- Rotor With Internal Bearings
- PTO Shaft With Overrun Clutch
Options
To view Options Details, click on the corresponding Accordion Tab in the right sidebar area.
- Distributor Kit
